500 results in 0.1337 seconds.
-
I thought that I had a bad spot on my line, but turned out to be OK. So, I just ended up replacing the fluid and bleeding. My RAP was not providing... -
If you're okay with ethanol in your gas be prepared to be okay with water in your gas also. One of the characteristics of ethanol is that it draws water... -
I have some Hydraulic fluid left over from my floor jack, will that work?Leave a comment:
-
The best thing is that in 2024 things will start to get back to normal? The worst thing is that it will take a lot longer than it should to get there...Leave a comment:
-
I'm going to replace the line from the rap to the shock. The shock is installed on the bike with the banjo fitting facing down. When installing the...Leave a comment:
-
-
Aerosol Seafoam
Has anyone used the Aerosol version of seafoam spraying straight into the carb? What were the results? -
Also the pulley is on backwards, not sure if it matters? But the manual say's the the raised center faces in....
Leave a comment:
-
The shaft on my front pulley sticks out more past the nut at the end than your does? Yours looks flush. Have you check the torque on the nut? If it...Leave a comment:
-
But that still doesn't give a reason for why they fall out unless they should provide a different spring with the new pilot screLeave a comment:
-
I have a 40 pilot jet in my bike. Brian you might be on to something, they may have made that one to fit just the stock pilot.Leave a comment:
-
Well, installed new OEM pilot screw kit. Set it at 2 3/4 turns out running great! That is where the highest idle was. I would advise to save your money...Leave a comment:
-
Mine was running fine at what I thought was 2 1/2 out. The last time I was messing with it, I found that the heater plug was slightly rubbing against... -
Bike had been running good. Yesterday I had one backfire turning into my neighborhood. Got on to ride today and made it about 2 miles and starting backfiring...Leave a comment:
-
Damn Barons pilot screw!
Went for a ride to the store bike started backfiring so I pulled over. Found out my $40 adjustable barons pilot screw fell out! Got it started and rode...
Leave a comment: