500 results in 0.1006 seconds.
-
-
-
Those are adjustable dog bones on either side of your shock. You can raise the height of the bike by adjusting those. You should get a service manual...Leave a comment:
-
from SC
Leave a comment:
-
The stock bard are 8" rise. I just subtracted 8" from the rise on the new bars and added that amount to the OEM length cables. If you go to...Leave a comment:
-
Nice build!!!!
So, I guess there's no more bandwidth problem???Leave a comment:
-
I thought that I had a bad spot on my line, but turned out to be OK. So, I just ended up replacing the fluid and bleeding. My RAP was not providing... -
If you're okay with ethanol in your gas be prepared to be okay with water in your gas also. One of the characteristics of ethanol is that it draws water...Leave a comment:
-
I have some Hydraulic fluid left over from my floor jack, will that work?Leave a comment:
-
The best thing is that in 2024 things will start to get back to normal? The worst thing is that it will take a lot longer than it should to get there...Leave a comment:
-
I'm going to replace the line from the rap to the shock. The shock is installed on the bike with the banjo fitting facing down. When installing the...Leave a comment:
-
-
Aerosol Seafoam
Has anyone used the Aerosol version of seafoam spraying straight into the carb? What were the results? -
Also the pulley is on backwards, not sure if it matters? But the manual say's the the raised center faces in....
Leave a comment:
-
The shaft on my front pulley sticks out more past the nut at the end than your does? Yours looks flush. Have you check the torque on the nut? If it...Leave a comment:
Leave a comment: