jd750ace
Last Activity: 2 hours ago
Joined: 10-19-2006
Location: Waxahachie Texas
-
JB don’t stand a chance! Broke 2 of those myself. -
Had the same thing. A heat shield clamp touching the linkage.Leave a comment:
-
Well, once you have had a truly GOOD helmet, you easily spot what is bad about cheaper helmets. I run full face, year round, every ride, and I can destroy...Leave a comment:
-
Bell is making one like that again (ancient design) and that Biltwell Chinese outfit. Couldn’t speak to the quality of either one. If you are not spending...Leave a comment:
-
It was never an issue of “can’t” but more of an issue of “don’t get your hopes up that it’ll make all your noise go away. Checking them is...Leave a comment:
-
I only use and trust genuine Mikuni jets for accuracy.Leave a comment:
-
Most stock lines are aramid fiber reinforced nowadays, and will swell under pressure. That's the common construction. Braided stainless sleeves are highly...Leave a comment:
-
It’s not for me. Just a question. Helping someone out and didn’t remember if a different reamer was called out. Only a half a thousandth of useful...Leave a comment:
-
Reaming valve guides
Does anyone know if the valve reaming prescribed for 04/05 SVS is done with the standard size reamer, P/N YM-04066 (6mm)? Thanks in advance. I thought... -
Glad you got it sorted out. Feels good, huh?...Leave a comment:
-
I carry a string plug kit (actually 2). I have run tires for 9K miles with just a properly installed string plug in them, on bikes. I’ve probably run...Leave a comment:
-
Generally, they look OK, if not a little lean. Every plug will have a clean side because the intake fuel washes it. The dirty side and the color on the...Leave a comment:
-
I use milk of magnesia for dissimilar metals a lot. We use it on the igniter plugs on certain aircraft because any petroleum carrier can induce a hot...Leave a comment:
-
Cycle terminal.com has that 6 pin plug. My headlight plug disintegrated over time and I bought a new ceramic off Amazon with new terminals and just cut...Leave a comment:
-
It’s OK to have to nudge it, but you don’t want to feel a breakout force, as in, when you push on it you should not feel the amount of effort change...Leave a comment:
-
If you get the middle 1/3 of your steering travel to not flop, then still have your issue, the neck is not the cause of your issue. With the overturning...Leave a comment:
-
I agree with Rod. Especially if the vertical on your bars is not parallel with the fork tubes, monkey bars create an overturning moment that makes it...Leave a comment:
-
Sounds like a clogged pilot jet to me.Leave a comment:
No activity results to display
Leave a comment: