Lug Nut
Last Activity: 12 minutes ago
Joined: 02-14-2018
Location: Avilla, IN
-
When I have everything pull apart I will use brake cleaner on a rag to get everything clean to inspect the race and bearings... if they look good not... -
Lug Nut replied to What the holy spiderman race bike wheelie bar rat shit fucked up abortion is this?/in Bike TalkIt's just such a hack job....if I had more time I'd ride down and look at it I person lol.......Leave a comment:
-
I like to get the bike level with wood under the kickstand and let both plugs and filter drain for about an hour make sure everything's out.Leave a comment:
-
Lug Nut replied to What the holy spiderman race bike wheelie bar rat shit fucked up abortion is this?/in Bike TalkI would buy it for $50...that's itLeave a comment:
-
Lug Nut replied to What the holy spiderman race bike wheelie bar rat shit fucked up abortion is this?/in Bike TalkAnd a snuperchirger...Leave a comment:
-
Lug Nut replied to What the holy spiderman race bike wheelie bar rat shit fucked up abortion is this?/in Bike TalkPics...
Leave a comment:
-
Lug Nut started a topic What the holy spiderman race bike wheelie bar rat shit fucked up abortion is this?/in Bike TalkWhat the holy spiderman race bike wheelie bar rat shit fucked up abortion is this?/
-
Plugs are fine. We all have to remember this is an antiquated big B-twin air-cooled very simple motor. This is not a finely tuned thousand horsepower...Leave a comment:
-
It's reported on liner forums quite a bit but need to keep in perspective. I don't know but maybe 2 to 3 percent have that issue...Leave a comment:
-
I have an '07 with third gear issue lol. There are several people that have had this issue but a comparison to the amount built obviously not a significant...Leave a comment:
-
When you look at them make sure to check the frame and swing on for cracks and make sure to drive it and really listen carefully as you hit third gear...Leave a comment:
-
You got that right.......Leave a comment:
-
Killer HornetsLeave a comment:
-
I would be very wary of '06 and '07 models. The transmission problem can creep up at any mileage and then you have a noisy bike and worst case scenario...Leave a comment:
-
chain instead of belt drive? I have a roadstar 1700 that was converted from belt drive to chain drive in a small custom bobber. Not that bad of an ordeal...Leave a comment:
-
That's a lot of torque for sure. Horsepower you're probably going to stay at that level no matter what else you do. They just don't seem to go much above...Leave a comment:
-
Does it still make 92 HP and 128 lb_ft torque (175 nm) to the tire?
Are you really turning 8000 rpm and if so what valvetrain are you using...Leave a comment:
-
Take a look at how Magnuson supercharger setups for the Roadster are fitted. Probably going to be fairly similar....Leave a comment:
-
What diaphragm spring are you using in your clutch setup?...Leave a comment:
-
Open up link and save to your phone on desktop or on home screen...Leave a comment:
No activity results to display
Leave a comment: