Brad_G
Last Activity: 1 minute ago
Joined: 06-16-2017
Location: Solon, IA
-
Removing caliper pistons
Been working on a project '03 Road Star over the winter. I noticed when removing the rear wheel that the caliper wasn't releasing as it should. So figured... -
When you say "jap front ends" are you talking wheels? There are some other model bikes that have direct bolt up. Lug Nut had a Stratoliner front... -
How many miles a year do you put on your bike. For those folks that only put on a few thousand miles a year the Shinko 777 would be good as you'll replace...Leave a comment:
-
ACEMUSTANG2002 yeah just thinking about if the gauge itself is that sensitive to vibration or if there is an electrical issue causing it. -
Brad,
Electronic cruise control??? I didn't know that was available? Do you know what company and how much trouble to install?
... -
That's a twin to mine all the way down to the electronic cruise control! Did the rear turn to run/brake/turn mod as well. I still need to get my front... -
That's what I do as well.
-
Duke, glad to see you post this. It seems it's often overlooked that they sponsor this site and keep the lights on here, which I'm very grateful for....Leave a comment:
-
from Solon, IA
From what I recall if you're not changing the air intake to a different setup you can get by switching pipes without...Leave a comment:
-
Do you have to use a second key now or did you find a way to put your locking parts on the new cap? -
Did you have to cut the outside of the harness? Just curious. I'm going to be putting Freedom duals on my '08 here very soon and just wondered what I'm... -
I'm not an expert in this area by any means. But from what I've read the system changes from closed loop to open loop in regards to the O2 sensors depending...Leave a comment:
-
If the tach isn't attached to the bars (holding it in your hand next to the bike) is it smooth or does it still bounce?Leave a comment:
-
Thanks davej for that explanation. I presumed Yamaha engineers figured there was value or they wouldn't have put it on and saved a couple bucks. -
Many will do it to clean up the left side of the bike for aesthetic reasons. The other is that it eliminates a potential point of failure. Carb motorcycles...Leave a comment:
-
cike well an old thread but it's really getting to the realization of what it is. A discontinued bike (close to 10 years now) that OEM and aftermarket...Leave a comment:
-
Can you post a picture of what you're calling the starter relay? Not to come off as an ass...but I can't think of how this would be possible if you truly...Leave a comment:
-
Taking off the seat would be less than ideal to read it though. Also, I'd wonder if there's enough clearance under the seat if you plan to leave it i... -
She must have thought...."if a little is good a whole lot has to be better..."
-
No activity results to display
Leave a comment: