Clutch stack

[Bear1433]

Xv1600 Wildstar 2002.
Hi all, been having endless trouble with my clutch since changing the friction plates a couple of years ago symptoms are after about 15 miles the whole thing goes out of adjustment! I have to pull up and readjust then again 15-20 miles later. We have had the bigger apart at least 5 times and have checked everything and all is within working tolerance all bearings are tickity boo! The only thing I have not done is change the steel plates but they have zero warpage and no blueing. I have ordered some new friction plates because the last ones I got off of eBay and though EBC ones I've been told there is a lof of fakes out there so this time I have ordered direct. But I want to check my stack height before installing but I can't locate this anywhere on the net so does anyone on this forum have this info? Stab in the dark but I'm wondering if they are Chinese junk they may be warping under heat and pressure

[Bikerron]

Looking for specific specs on the web is always a shot in the dark. It sure keeps Snopes busy.
It’s all in the Yamaha Service manual. I can’t see anyone that delves deep into the working innards of their bike without one.

Someone on here can link you to a .pdf file for your bike, but they’re a bit of a pain for my tired eyes flipping back and forth. I can’t remember where the link is.

I bought the real thing off eBay. Lightly used, but very well worth the money. And I got it for about $25 shipped.

You haven’t filled out your profile on the bike so I can’t give you an exact example.

Mine’s an ‘09 and here are the specs.

[Bear1433]

Ok many thank..plug and play and pray!!! Sorry I don't know why my bike profile see show up?
another bloody thi g to fix