Announcement

Collapse
No announcement yet.

another jetting question

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #21
    Not sure on the needle brand. was in the carb when I got the bike. My guess is a Baron's comparing it to photos. I have the 40 in it now. think I should put the 37.5 back in? enricher cover has been replaced with an aluminum one from Lugnut. Also has the aluminum mainfold. I put new plugs in it and it is running good with no popping or misfiring now.

    Comment


    • #22
      But plugs should last 20k+miles...40 pilot is correct. If needle has multiple grooves its the Barons (or maybe dyna?).
      LET'S RIDE

      Comment


      • #23
        might want to check the float height ? i run a 0.040th pilot 175 main, 2 3/4 turns out pms baron needle on the 4th clip from the blunt end plastic washer only, or are you just using this for an excuse for a road test like Mickyc said, don't tell the wife

        Comment


        • #24
          Bike just seems to running rich. Trying to figure out why. Dose the pms meters the fuel correct?

          Comment


          • #25
            Sounds like bike is broken and can't be fixed. I'll give $800 for it. I'll pick up next week?!!!!!!!!???!?!?
            LET'S RIDE

            Comment


            • #26
              yea right. lol

              Comment


              • #27
                gonna pull the carb today and make sure plastic spacer and all is in the correct positions on the needle and check position on pms

                Comment


                • davej
                  davej commented
                  Editing a comment
                  Barons needle and Dynojet needle look the same to the eye but they are different. try the 3rd groove with the clip.

              • #28
                I believe the Dyna needle set in the 4th groove would be the same as a Barons needle set in groove 3 1/2 so it would be just a Tad leaner than the Barons needle. You can always just add a shim washer for a total of 2 under the clip to make it almost exact to the barons needle
                LET'S RIDE

                Comment


                • #29
                  Buy using measurements i found on here looks like I have the dyna needle. Moved clip to 3rd slot. Bike seems to run good with good response. Only issue now is when starting from a stop and light throttle the bike hesitates and almost shuts off.(did shut off once during test ride) More throttle it takes off fine. So go back to 4th slot and adjust the pms or just try to adjust the pms first?

                  Comment


                  • #30
                    put the 172.5 main and 40 pilot in it and 3rd groove with a plastic spacer and 1 silver washer under the clip. Make sure the idle is at 900-950 and not a low loping idle.

                    Comment


                    • #31
                      I have all that except for the washer under the clip. I only have one washer on top of the clip. Is it ok to put it under the clip and not have one on top? If not I will have to get some.

                      Comment


                      • #32
                        Originally posted by Rick Fortner View Post
                        I have all that except for the washer under the clip. I only have one washer on top of the clip. Is it ok to put it under the clip and not have one on top? If not I will have to get some.
                        Yes, just use that one. Its a spare, well not now.

                        Rod

                        Comment


                        • #33
                          Put shim under the clip. Bike is running great so far. Will pulled the plug in a couple hundred miles and see how they look. Thanks for all the help.

                          Comment


                          • #34
                            Originally posted by Rick Fortner View Post
                            Put shim under the clip. Bike is running great so far. Will pulled the plug in a couple hundred miles and see how they look. Thanks for all the help.
                            OK... Since it's running better I'll up my offer to $900....lol

                            That is one of the best looking Road Stars Ihave seen in person!
                            LET'S RIDE

                            Comment


                            • #35
                              Sorry Scott I'll have to pass. Lol. And thank you. The way it looks and sounds is one of the big reasons i bought it.

                              Comment


                              • #36
                                It's sounding like a winning combination.
                                It's not that life is so short, it's just that you're dead for so long.---unknown.

                                Comment

                                Latest Posts

                                Collapse

                                Topics Statistics Last Post
                                Started by coolalexrex, 1 hour ago
                                1 response
                                13 views
                                0 likes
                                Last Post davej
                                by davej
                                 
                                Started by NCB, 1 week ago
                                18 responses
                                204 views
                                0 likes
                                Last Post NCB
                                by NCB
                                 
                                Started by Ahodge75, 12 hours ago
                                8 responses
                                37 views
                                0 likes
                                Last Post NCB
                                by NCB
                                 
                                Started by TheDukeOfYamaha, 17 hours ago
                                3 responses
                                57 views
                                1 like
                                Last Post Tcontrol  
                                Started by BloodMoney, 4 days ago
                                5 responses
                                90 views
                                0 likes
                                Last Post BloodMoney  
                                Started by CanadaboyA, 19 hours ago
                                2 responses
                                53 views
                                0 likes
                                Last Post CanadaboyA  
                                Started by CanadaboyA, 1 week ago
                                13 responses
                                101 views
                                0 likes
                                Last Post CanadaboyA  
                                Started by roadiemort, 1 day ago
                                0 responses
                                32 views
                                0 likes
                                Last Post roadiemort  
                                Started by Jaybo, 02-26-2021, 10:22 PM
                                234 responses
                                3,168 views
                                3 likes
                                Last Post YamaDave  
                                Started by VinnieRSC, 1 day ago
                                8 responses
                                59 views
                                0 likes
                                Last Post VinnieRSC  
                                Started by Shores, 3 days ago
                                18 responses
                                126 views
                                0 likes
                                Last Post Shores
                                by Shores
                                 
                                Started by AR. Hillbilly, 03-13-2021, 07:23 AM
                                62 responses
                                1,023 views
                                1 like
                                Last Post AR. Hillbilly  
                                Started by Kevin Gibson, 2 days ago
                                25 responses
                                159 views
                                0 likes
                                Last Post Kevin Gibson  
                                Started by Papi, 1 week ago
                                5 responses
                                164 views
                                0 likes
                                Last Post Shores
                                by Shores
                                 
                                Started by Cwjackson2021, 6 days ago
                                13 responses
                                92 views
                                0 likes
                                Last Post Ace
                                by Ace
                                 
                                Started by BlueRidgeSasquatch, 6 days ago
                                15 responses
                                89 views
                                1 like
                                Last Post Ace
                                by Ace
                                 
                                Started by Kmartcivic, 1 week ago
                                4 responses
                                78 views
                                0 likes
                                Last Post Kmartcivic  
                                Started by Texter, 1 day ago
                                0 responses
                                40 views
                                0 likes
                                Last Post Texter
                                by Texter
                                 
                                Started by jimlun, 1 week ago
                                7 responses
                                151 views
                                0 likes
                                Last Post roadiemort  
                                Started by Neil, 4 days ago
                                4 responses
                                135 views
                                0 likes
                                Last Post Bikerron  
                                Working...
                                X