Bike won't move in gear

[6door7r]

Posing this question here because not everyone is in the Facebook groups. I need some help from the experts.

My 02 broke down on me a few days ago. I was riding and all of a sudden I lost power to the rear wheel. My first thought was clutch related because I had been doing slow speed friction zone cone course riding when it happened. I had already been having slippage at high RPM's if I crank the throttle to pass someone and had planned on doing the Barnett conversion. I checked my pulley nut and it is tight, but I do need to get it off and check the splines

In gear while on the ground, I give it throttle and nothing happens. On a jack, the rear wheel spins slowly in gear but doesn't respond to any throttle.

Any help is appreciated.

Thank you!

[Lug Nut]

Sounds like you could have killed your clutch completely. Remove clutch cover and inspect ...measure friction discs (I bet they are toast)....oil probably nasty after all that practice also.

If you didn't hear or feel a bang/thud/jolt it would seem to be clutch related...

But...have to check transfer case/pulley nut/jackshaft also....

[brianmac]

did u take off the pulley and inspect splines like I advised on facebutt?

[6door7r]

did u take off the pulley and inspect splines like I advised on facebutt?

Not yet. That's why I mentioned here that I still needed to do that.

[6door7r]

Just realized I put this in the classified section. Oops.... that's what I get for posting when I should be sleeping