Tweet
used the template, as pictured. I used (2) 6” X 1/5” X .5” Flat Bar (steel). Drilled the holes with a 3/8" bit. I primed, painted (flat black) and put some gloss clear coat on them. You will see tool marks around the holes since I cleaned the paint out the holes with the bolts to make sure they fit.
This set will extend your floorboards ahead 3.25" at a 15% angle and will accommodate the Harley Engine Guard. I do not know which Harley engine guard will work but there is a picture with measurements attached.
You can use the rear brake line still but you will need to remove it from the mounts.
You use your existing floorboard bolts and you will need the following to mount the extended floorboards.
$32 shipped in CON-USA
This set will extend your floorboards ahead 3.25" at a 15% angle and will accommodate the Harley Engine Guard. I do not know which Harley engine guard will work but there is a picture with measurements attached.
You can use the rear brake line still but you will need to remove it from the mounts.
You use your existing floorboard bolts and you will need the following to mount the extended floorboards.
- (4) M10 1.25 1.25” stainless steel bolts
- (4) M10 1.25 stainless steel lock nuts
- (4) Stainless Steel washers
$32 shipped in CON-USA
Comment